- Factory Reset the router to ensure it is in
default mode (refer instructions below).
- Ensure the "Modem" port on the router is
connected to your ADSL/Cable modem by an Ethernet
cable.
- Type the router's URL into the internet browser
(address bar in Internet Explorer),
http://192.168.2.1/
- Once the login page appears, enter the password
as admin, Click OK
- A "Security Advice" page may appear, Click OK.
- Click the "Basic Setup Wizard" link
- On the Welcome-Wizard page, click the "Next >"
button to start the wizard
- Select Australia as the Country and Click the
"Next >" button
- Next to the "Protocol" option, click the drop
down list and select "Dynamic IP"
- Next to the "UPnP" option click the "On" button
- Click the "Next >" button
- On the Apply Settings page, clear/uncheck the
tick box and click "Finish"
- A warning message may pop up, click OK
- A message will pop up asking to reboot the
router, click OK
Your router is now configured for Dynamic IP
Resetting SE551 wireless router to Factory
Defaults
Resetting the router may be required if you have
changed the router’s settings and wish to reset it to
the factory default configuration.
Note: Resetting the router will wipe all previous
configurations and may need re-configuration to set up
in your environment.
SE551 Wireless Router
- If not already unplugged, unplug
the power to the wireless router.
Wait 2 seconds then plug it back
into the power turn the router on.
- Wait 5 seconds, until the router
has stopped booting up. The 'Power
'and 'WLAN' lights will then go
solid green
- Insert a small tipped object (a
pen tip will do) into the reset hole
underneath of the wireless router,
this will be found close to the LAN4
light. You will need to hold this in
for at least 5 seconds until the
WLAN light turns off. As soon as you
see the WLAN light turn off you then
need to release the button. ... wait
15 seconds.
- You will see the WLAN light and
the LAN1-LAN4 lights flash briefly.
If not, repeat Step 3.
- Unplug the power to the wireless
router
- Reboot laptop/PC. Power off your
ADSL/Cable modem, then turn back on
- Finally plug the power back into
the SE551 wireless router to turn
back on
--- |
|
|
